4 Axis CNC USB MACH3 100Khz Breakout Board
ตรงนี้มีภาพ! แต่ท่านจะมองไม่เห็น , ท่านต้อง สมัครสมาชิก หรือ ลงชื่อเข้าระบบ
(https://www.arduino4pro.com/product/1144/4-axis-cnc-usb-mach3-100khz-breakout-board)
Specifications
Product type : 4 Axis CNC Breakout Board
Interface : USB
Maximum step-pulse frequency: 100 KHz
Automatic probe tool Support: Yes
Emergency input: Yes
Limit switches: Yes (4 general-purpose inputs, you can connect the limit switch, estop switch, probe switch, back to zero and other device)
External Voltage: 12V/24V
Spindle Control Output: Yes (0-10V output port)
Size: 8×7.7cm /3.15×3.03inch
Tested with following Operating Systems:
Windows XP (direct)
Windows 7 64bit /32Bit (direct)
Windows 10 (Indirect using Windows XP on VmWare)
Setup Instructions
Step 1: Install Mach3: If you already have a Mach3 Installed, skip this step.
Step 2: Download the USB Motion Driver RnRMotion.dll from the link down below and copy and paste the file into your Mach3 Plugins folder Example: “C:/Users/ProgramFiles/Mach3/Plugins”
Step 3: Make sure you board is connected to the PC via USB cable. It should automatically recognize the USB device.
Step 4: Open Mach3 and you should be prompted to select a driver. Select the “RnRMotionController” and check “Don’t ask me again”. This will allow your board to communicate with Mach3.
Step 5: Download the XML Mach3 Config File above by right clicking on the link and selecting “save as”. Save the Mach3Mill.xml file in your Mach3 root folder.
Datasheets
Wiring diagram
Software installation
Website