##########################################################
About Ui16 V1.0 build 5465-ui16
##########################################################
Feature Enhancements:
ยท Synd ID feature added (multiple browser windows staying in channel Sync)
ยท Support for EDGE (latest Microsoft browser)
ยท "MoreMe" Portrait Mode ON/OFF - On by default (Settings)
ยท Working Enabled/Disabled broadcast SSID
ยท Channel MUTE mutes Aux Sends as well in PFL mode
ยท Global Pre-Fade Aux Send Point โ€“ Pre-Processing or Post-Processing, Post by default
ยท AFS2 removed from SHOWS/SNAPS and now uses it's own preset manager
ยท MAC Address visible in Network Settings
ยท New Hard Lock (admin/pass) Access limitations system
ยท Local user Settings presets feature in Settings
ยท Reset Local user Settings to default feature in Settings
##########################################################
Software Update Instructions for Ui16 V1.0 build 5465-ui16
##########################################################
01. Download the uiupdate file from the Soundcraft website. The format is: uiupdate-k-1.0.5465-ui16.zip (leave in zip format)
02. Copy the file to a USB media device suitable for connection to a Ui mixers USB port.
Note: The file can reside in any directory. Any USB port on the mixer is acceptable.
03. Ensure a client device is connected to the Ui mixer GUI.
04. Connect USB media to the Ui mixer
05. The GUI display will display that the USB device has been mounted. After the stick has been read (10 more seconds) the update will be recognised.
06. The GUI will prompt you if you would like to update the Ui mixer. Options are Ok/Cancel.
07. Select OK to confirm
08. The Ui mixer will perform a firmware update
09. The GUI will present a message stating whether the update has been successful or not.
10. You must power cycle the unit and reconnect the client device. Power off for at least 10-15 seconds before powering back on.
Note: A flick of the power off/on may fail to boot properly and display a continuous flashing blue wifi led. Make sure to power off, wait 10-15 seconds, then power on. The blue wifi led will pulse/flash for 10-15 seconds then remain on."
11. You can now browse to the about page to see the new firmware version information.
########################################################################
RESET TO FACTORY DEFAULT FIRMWARE
########################################################################
********************************IMPORTANT*******************************
This method removes all updates you may have performed on the mixer and returns
the mixer to the default factory shipping firmware and state. Please ensure you
have saved/backed up any shows before resetting your Ui.
************************************************************************
RESET TO FACTORY DEFAULT FIRMWARE
=============================================================================
The following procedure will restore the console to the factory defaults.
NOTE: All settings, snapshots, users, profiles and shows will be lost.
01. Create a test file named fullreset.txt (no contents necessary) and copy to a USB stick
02. Insert the USB stick into one of the Ui's USB ports.
03. Use a slim, long object (paper clip) to hold the reset button down for approximately 10 seconds while you power on the unit.
04. The Ui will recognise the fullreset.txt file on the USB stick and perform a full factory reset.
05. 10. You must power cycle the unit and reconnect the client device. Power off for at least 10-15 seconds before powering back on.
Note: A flick of the power off/on may fail to boot properly and display a continuous flashing blue wifi led. Make sure to power off, wait 10-15 seconds, then power on. The blue wifi led will pulse/flash for 10-15 seconds then remain on."
