How to Generate PWM with variable Duty Cycle and Frequency Using IC 555 We are supplying +9Volt as input to IC555 timer but we can give input from +4.5 volt
to +16 volts, it depends on output waveform we desire. Say we need an output waveform
of +12Volts then we will give input as +12volts.
ตรงนี้มีภาพ! แต่ท่านจะมองไม่เห็น , ท่านต้อง
สมัครสมาชิก หรือ
ลงชื่อเข้าระบบComponents used are:U1 - IC555 Timer
Capacitors:C2 - Electrolytic capacitor of 10uF 100Volts
C1 - Ceramic capacitor of 10uF
C3 - Ceramic capacitor of 0.1uF
Resistors:R1 - 4.7 K ohms
R2 - 470 ohms
Diodes:D1 - D2 - 1N4148
Potentiometer:P1 - P2 - 100k
P1 and P2 are variable potentiometers Rpot1 and Rpot2 respectively.
I had used 100k potentiometers but you can also use 1k or say 1M potentiometers,
it all depends upon the resolution you want, more precise resolution you require,
more should be the value of potentiometer.
Now by varying the potentiometers Rpot1 and Rpot2 we can vary Duty cycle and
frequency respectively of the output waveform as shown below. If we want more
frequency we have to reduce size of C2 electrolytic capacitor, C2 capacitor and Rpot1
and Rpot2 are known as Timing circuit, by varying Rpot1, Rpot2 and C2 we can get
different different frequencies from 1HZ to 1Mhz.
Frequency depends upon the formula:
Freq = 1.44 / ((R1 + R2) * C)
Output waveform:ตรงนี้มีภาพ! แต่ท่านจะมองไม่เห็น , ท่านต้อง สมัครสมาชิก หรือ
ลงชื่อเข้าระบบ ข้อมูลมาจากที่นี่...